Dụng Cụ Lăn Vải/Giấy Dán Tường

This is a small roller I made to help with my wife's sewing. It can also be used for rolling the edges of wallpaper or anything you need to roll flat.

The roller diameter is 20mm and 25mm wide. Overall length when assembled approximately 180mm (7 inches)

The roller internal hole diameter is 5mm, the holes in the handle are slightly smaller to allow a bolt to thread into the plastic. A 5mm x 40mm bolt with nut should fit fine but two smaller bolts 10-15mm) without nuts can be fitted at each end instead if that makes it easier to source.

Print Settings

Printer:

Tronxy x5s

Rafts:

No

Supports:

No

Resolution:

0.2mm

Infill:

35

Filament:

Surreal PLA

Notes:

Use at least 2mm walls (5 shells) and 2mm top and bottom for the handle and it should be plenty strong enough.

No supports needed for any parts.

Category: Hobby