Nắp An Toàn Cho Đui Đèn E27

1.- Introduction:

In the garden I have a light chain (Light bulbs Guirlanda). In the far past, the bulbs were regular Incandescent light bulbs which were waterproof sailed. 

In these days, they were replaced by regular led bulbs which are not waterproof sailed, therefore after few days of rain, the bulbs start to get filled with water.

Therefore I had the motivation to design a cap for replacing bulbs until the rain season ends (The caps will prevent from water to go in and for insects to build their homes there).

The same caps can be used at home for covering light bulb sockets that have no bulbs to prevent getting electrocuted by mistake.

Explore my other Printables: https://www.printables.com/@rbid/models

2.- Printing:

There are two versions, one with a small handle and one that is like a taller cylinder. Pick the one that is suitable for you. 

No supports are needed, I printed them in PET-G but can be printed in any other material that is not conductive.

2.1 Regular Cap with handle:

File

regular-safety-cap-for-e27-light-socket-v1.3mf

Filament

2.65 mt. (8.09 gr.)

Time

48 min.

2.2.- Cylindrical cap:

File

cylindrical-safety-cap-for-e27-light-socket-v1.3mf

Filament 

3.59 mt. (10.78 gr.)

Time

1:05 hrs.

3.- Change Log:

• Upload: 2024-02-08: Initial Version.
   

4.- Last Words

Please don't forget to ★ Rate and ❤ Like

Post your Makes to earn Prusameters!

Do not hesitate to ask questions, feedback is essential to making better models.

You are kindly invited to follow me to get updated when upload new models.

Happy printing & Greetings from the Galilee.

Hope it was not TL;DR