Giá đỡ đèn pin cho đèn LED Coast HP1

I keep this little Coast HP1 LED Flashlight in the door panel of my truck, but I hated it rattling around. I used some Joe's Sticky Stuff (this is great stuff BTW) to attach it to the plastic inside the truck.

This is where I wanted it, here was a test fit of just the flashlight:

Here it is installed:

Print Settings

Printer Brand:

Prusa

Printer:

Prusa Mk2

Rafts:

No

Supports:

No

Resolution:

0.2mm

Infill:

20%

Notes:

Make sure to orient the flat surface on the bed (should be the default orientation of the part), printing it any other way will cause you some headaches.

I used PLA, I fully expect this thing to melt in my truck (in hot Florida sun). Will see what happens, if it does I'll re-print in PETG or something like that.

Category: Organization