
Giá đỡ và phân phối cuộn dây jute tiện lợi
- Downloads
- 40
- Likes
- 12
- Views
- 385
- Remixes
- 0
- Comments
- 0
Files 3 1 MB
- Cylinder_1766337221.stlSTL · 326.2 KB
- Led_1766337222.stlSTL · 695.6 KB
- Lock_1766337223.stlSTL · 36.7 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #1438
- Category
- Mỹ Thuật
- Published
- License
- Creative Commons — Attribution
Description
I needed to keep a Jute String Roll / Yarn safe from getting tangled (or loss) with an easy way to dispense. I looked around and couldn’t find something that will fit my needs specially that I had a cylindrical shaped roll, I utilized FaberUnserzeit customizable round box with threaded lid design found in thingiverse. I’ve added two extra things to it, a center rod to hold the roll in place within the cylinder while allowing it to roll out freely and a vertical opening in one side to help in dispensing the string when needed. I’ve also designed a small lock to hold the pull string in place (at top or bottom) when not in use, that also can double as a guide if you need it.
Dimensions:
The cylinder radius is 100mm and its 183mm high without the led-on top.
The Led is 13mm high.
The lock is 16mm wide x 7mm depth x 10mm high
Note about the lock:
- If the lock is not holding in place the way it should you can scale it up or down as needed it a small print and you should not have problem reprinting it as needed.
- Use the middle of the opining in the cylinder to push the lock in, it should be easy after that to slide it upward or downward as needed.
Print spec
- Formats
- stl
- Model files
- 3
- Total size
- 1 MB
- Largest file
- 695.6 KB
0 comments
You may also like 12 models
See all-

-

-
New -

-
New -

-
New -

-

-

-

-


