Hộp đựng Ciga Giữ Bật Lửa

A heavily edited version of Ezequiel's Box with thumb tabs. Kept the tolerances of the original since they work well. 

• The pivots probably print fine as is without supports but I print supports anyway since its close to the bed and for reassurance.
• The two parts will fit nicely but loose, for a tighter fit put electrical tape over the pivot holes in the box before joining.
• The slanted face I thought would be an interesting appearance but doesn't really allow for hole compensations in slicers, but should be ok with consistent layers.
• The lighter holder has a compliant arm to allow for wider tolerance and potentially slightly differently shaped lighters. 
• This box is sized to 100s, the model could be shortened to only fit smaller ones..

Still takes a bit of persuasion to assemble.