
Điểm vào ống PTFE cho Vỏ che Prusa
- Downloads
- 96
- Likes
- 24
- Views
- 654
- Remixes
- 0
- Comments
- 0
Files 1 240.3 KB
- Enclosure_Filament_Entry_PTFE_Guided_1766675473.3mf3MF · 240.3 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #139541
- Category
- Máy In 3D
- Published
- License
- Creative Commons — Attribution
Description
As I occasionally print Manual Multicolor and always print via PTFE Tubes out of Dryboxes, I place my Drybox on top of the Enclosure and need a way to guide the PTFE in. For me, coming via the top seems natural.
So, I designed this entry point for up to five PTFE Tubes.
This is my third iteration, now using another five larger diameter PTFE Tubes (5mm/6mm ID/OD) to guide the PTFE tubes between my Drybox and the printhead as this drastically reduces drag and eliminates some issues I had before where the Filament Tubes could catch on something, or lowering z axis needed you to assist if to much of the Tube was outside of the enclosure.
Printing:
It should be quite straightforward; no support is needed, and nothing is hard to print. I used Prusament PETG and a 0.4mm nozzle.
Print as many Plugs for unused holes as you want.
Additional Materials:
You need a couple of centimeters of a 5/6mm ID/OD PTFE tube like this from Amazon Germany https://www.amazon.de/DMiotech-Schl%C3%A4uche-Schlauch-Isolierrohr-3D-Drucker-Filament/dp/B0C7QJ4PV7/ref=sr_1_1?keywords=PTFE+6mm+5mm&qid=1707040441&sr=8-1
Installation:
- Insert the 6mm PTFE from the bottom of the part and cut to length with a sharp knife.
- Use the original plastic rivets to secure the place in the enclosure (I could reuse mine after carefully pushing out the pin on the original part.
Print spec
- Formats
- 3mf
- Model files
- 1
- Total size
- 240.3 KB
- Largest file
- 240.3 KB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -
New -
New -

-

-

-

-


