Giá đỡ tay cầm iOptron Tri-Pier 360

Used Overture grey ABS at 265C nozzle, 110C bed with .8mm nozzle.  Prusa MK3S+

No supports or brim. Smooth PEI bed.

Note the handset bracket (the part the handset goes into), has a sloped surface on the inside edge on the front.  This should be glued so the sloped edge is on the top.  This is to keep the handset buttons from hitting the edge if it were square.

Once glued together, you will need an 8mm bolt.  Screw it into the pre-existing tapped 8mm hole on the corner of the pier top plate from the bottom.  There are 4 on the 360, your choice.  Get one long enough to protrude through the top plate and handset bracket, leaving enough length to get a wing nut, lock washer, and flat washer on.  Tighten gently, barely finger tight.