Skip to main content
F3D
Ống Dẫn Dây Tóc AnkerMake M5C Gắn Sau 1

5 images

Máy In 3D

Ống Dẫn Dây Tóc AnkerMake M5C Gắn Sau

Remix of Bộ Dẫn Dây Tóc Thay Thế Cho AnkerMake M5C By just_trey_187373

By KeWe_1093767

Downloads
386
Likes
49
Views
2,571
Remixes
1

Files 4 609 KB

  • M5CFilamentGuideOver_1766184450.stlSTL · 162.3 KB
  • M5CFilamentGuideUnder_1766184451.stlSTL · 184 KB
  • M5CFilamentGuideBraceSlim_1766184452.stlSTL · 118.1 KB
  • M5CFilamentGuideBrace_1766184453.stlSTL · 144.6 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Description

I'm using my M5C with the filament spool at the rear and the included filament guide doesn't work well with it. I really like the original model by just_trey so i made a remix that works better with rear mounted spools.

There are two guide models, one that goes “over” and one “under” the top of the frame. PTFE tube goes into top, filament in the bottom, you can reuse the clip/clamp from the included filament guide.

I also made a brace in case the filament guide slightly cracks when putting it on the printer frame. Print the brace at 101% otherwise it might be a tight fit. (Slim model is slightly thinner, but support is not as strong.)

Both models work with PLA, but will work better with PETG since they need some flex.

(Note: Mounting the spool at the rear will limit compatiblity for very big models that cover the whole bed while also exceeding the height of the spool. But for most models it works perfectly fine. Not an issue with small 250g spools.)

Read more Show less

Print spec

Formats
stl
Model files
4
Total size
609 KB
Largest file
184 KB

0 comments

See all