
Bộ Nối Dài Chân Tủ Ikea Metod (402.055.99)
- Downloads
- 100
- Likes
- 24
- Views
- 1,643
- Remixes
- 1
- Comments
- 0
Files 2 2.7 MB
- Ikea_Metod_Screw_On_Leg_Extender_15mm_1766347216.stlSTL · 1.3 MB
- Ikea_Metod_Screw_On_Leg_Extender_30mm_1766347219.stlSTL · 1.4 MB
Make a variant with AI
Build another version of this model.
Remix versions 1
The remix list could not be loaded right now.
See all 1 remixDetails
- Model ID
- #130934
- Category
- Đồ Gia Dụng
- Published
Description
Check my other IKEA designs:
NEW Ikea Metod Leg Extender (705.560.67)
IKEA Metod Back 10mm Spacer Replacement (10036383 or 10039201)
Why
If your robot vacuum cleaner does not clean under the Ikea Metod cabinets (standard 8 cm is at least 2.5 - 3 cm to low) or you just want to extend the legs. Use 15 mm or 30 mm file, whatever works for you.
I found some other projects but none of them was threaded and stayed firmly in place so I made this one from scratch.
Problem described on (among others) roborock forum and reddit.
I printed mine in black PLA-CF from Bamboo Lab
My settings:
- 0.4 nozzle
- 0.2 layer height for threaded part
- any layer height for the rest (I used 0.28)
- 50% rectilinear infill
- 3 shells (vertical, upper, lower)
But test by yourself as this have to carry some weight, unmodded are rated at max 125 kg load/leg
Assemble
Works with Ikea Metod Leg (article number 402.055.99)
- Remove the bottom lid (part 139994 in the manual)
- Screw the extender into the leg to the end
- You can still use the lower ring (part 139993) as the diameter stays the same
Caution
Don't use the extender to raise or lower the cabinets, use the thread in the leg as you would normally do without the extender
Print spec
- Formats
- stl
- Model files
- 2
- Total size
- 2.7 MB
- Largest file
- 1.4 MB
0 comments
You may also like 12 models
See all-

-
New -

-

-

-

-

-

-
New -

-

-
New

