
Giá đỡ cáp máy đùn cho Sovol SV06 Plus (chỉnh sửa)
Remix of Giá đỡ cáp đầu in Sovol SV06 Plus By itsrouteburn
- Downloads
- 160
- Likes
- 23
- Views
- 669
- Remixes
- 0
- Comments
- 0
Files 5 5.3 MB
- mainboard-cable-support_1765528785.stlSTL · 149.9 KB
- mainboard-cable-support_1765528790.scadSCAD · 3.2 KB
- itsrouteburn-Sovol_SV06_Plus_Print_Head_Cable_Support_1765528793.stlSTL · 33.5 KB
- sovol-sv06-plus-motherboard-box-front_1765528795.stlSTL · 2.2 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #130895
- Category
- Máy In 3D
- Published
Description
Keep your Sovol SV06 or SV06 Plus extruder cable elevated with this cable support! This remixes itsrouteburn's Sovol SV06 Plus Print Head Cable Support for better stability with a more snug fit.
Recommended pairing
This model pairs well with my extruder-mounted extruder cable support.
Printing
This prints with no supports and no special instructions.
Installation
Note: The original model installs on the front side of the extruder cable. This model is the opposite and installs on the back side of the extruder cable, facing away from the printer.
First, turn off your printer. Open the mainboard case by removing the screw on the rear.
Then, continue the installation with these instructions:
Photo of opened mainboard box
Insert the printed support into the cable lip with the grooves facing the rear of the box
Photo of support correctly inserted
Holding the extruder cable next to the support, thread a zip tie through the mainboard box lip holes, around the support and cable, and bath through the opposite hole
Fasten the zip tie
Close the mainboard box and re-install the screw
Attach a second zip tie around the support and extruder cable using the upper notches on the support. Trim the zip ties excess. All done!
Print spec
- Formats
- scadstl
- Model files
- 5
- Total size
- 5.3 MB
- Largest file
- 2.9 MB
0 comments
You may also like 12 models
See all-

-

-

-
New -
New -

-
New -

-

-

-

-


