Chân Đế iPhone Phẳng Siêu Tốc 27 Phút - Hướng Dọc

This is an iPhone stand designed to print flat on the build plate in multiple pieces that snap together. Goals were to print fast, use a minimum amount of filament, and to pack into a very small space. Although tested with iPhones, this will likely work well with other phones.

This has been printed with PLA but would also work well with PETG. The files included are sized for a typical phone, but could be scaled up for use with a tablet.

Printed at 0.3mm, this will complete in 27 minutes on an Prusa MK3.

This was designed to hold the phone in portrait orientation, but will work in landscape. I also have a landscape-only version that is smaller and will print in less than 15 minutes.