Skip to main content
F3D
Nêm Chặt Quạt Cho Dòng X / P 1

1 image

Máy In 3D

Nêm Chặt Quạt Cho Dòng X / P

By qwiktune

Downloads
92
Likes
23
Views
1,673

Files 1 25.1 KB

  • washer_1766155683.stlSTL · 25.1 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

A lot of X and P series owners like me have complained about rattle noise during fast prints and heavy vibration. If you haven't looked at the part cooling fan in the hot end cover yet, check and see if the screws that hold the fan in are loose. I've noticed that even though they might be screwed down the entire way, they could be bottomed out before they actually tighten the fan in place causing the rattle sometimes.

Remedy I found was using some sort of washer or Oring to fill that gap so I created this small washer to perform that duty for anyone who may run in to this issue and not have tiny washes laying around. I think assembly is self explanatory from the pictures, just put em on the screws and reinsert.

This wont fix a rattle issues coming from somewhere else, but if you suspect the fan, its a 2 minute print and very little work to be sure. It should also go without saying to use something higher temp resistant like PETG/ABS…etc

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
25.1 KB
Largest file
25.1 KB

0 comments

See all