Đế giữ mũi hàn chống đổ

I didn't like the existing models, because if you accidentally tip them over, the tips go everywhere. So I created this spill-proof holder.

Following versions are available:

1. Normal
2. Gridfinity
3. Screw mount for YIHUA soldering stations
   • Mount it on the opposite side to your hot air gun holder. There should be extra screw holes.
4. Magnet
   • Put 6x2 size magnets down the channels. To remove, insert a pin in the hole below.
   • You could instead just use the gridfinity version sideways. Remember, it's spill-proof.

Note

There's a test print to check the clamping force. You want it a bit tight, since PLA will loosen slightly in a couple days. However, even after months of usage, it doesn't loosen further.

If you want looser/tighter versions, let me know in the comments.

Print settings

No supports. Tested with 0.4 and 0.6 nozzles.