Đèn bàn Dummy 13

I wanted a desk lamp that looked need and funny.
I was inspired by https://www.printables.com/model/462366-lamp-man and thus tried to create my own. i relative quickly gave up as i can't model properly yet.
As i already had my mind on it, i changed the lamp cap and ring to fit the dummy's neck.
Scaled everything up a bit (250%) to fit a proper GU10 bulp and socket and started printing.

I used a GU10 socket, which fits in to the lamp snugly,
Inside the backpack i pushed a wire connector (those white with small screws) to connect the socket and power cable.

I drilled 2 4 mm holes at the back of the lamp to pass the wires through.
(This depends on the socket you get, most have 2 seperate wires but i have seen some single ones.)

As this is my first post/model showcase, i tried my best to meet al the requirement.
As the Dummy 13 and Backpack is non commercial and the lamp man is, i can't include it in the remixed models. Yet credit is due where credit is due. 
 https://www.printables.com/model/462366-lamp-man  is where i found the lamp man, i used the lamp (yet changed it) and the lamp ring. 

In case things need to be changed or removed. feel free to contact me and i will do my best.

Update 2023-12-13:
Added 2 new lamp cases with holes. 1 with 2 holes in the back, 1 with 1 hole on the bottom. (I didn't add them as i didn't know where the wires would end up and drilling some small holes quick work)