
Chỉnh Sửa Bộ Phận X End Prusa MINI
Remix of Các bộ phận in được cho máy in Prusa MINI+ By F3D Team
- Downloads
- 574
- Likes
- 83
- Views
- 1,803
- Remixes
- 1
- Comments
- 0
Files 2 478.5 KB
- MINI-x-end-Lock-v2_1768364791.stepSTEP · 297.2 KB
- MINI-x-end-Idler-v2_1768364793.stepSTEP · 181.3 KB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #126267
- Category
- Máy In 3D
- Published
- License
- GNU General Public License v2.0
Description
Revision of the Original Prusa MINI X End splitting the part in two: a fixed part to lock the X axis and a moving part for the idler, allowing an easier tensioning of the belt, which can even be done on the fly!
This part is based on the original part (rev2): the MINI will still look like a true MINI!
Two more square nuts are required (found in the spare bag). They should be press-fit inside the idler part.
Printed in PETG at 0.2mm layer height. For the assembly, refer to the original documentation. The differences are quite obvious.
Important: depending on the printer, the tolerances for the locking part might be a little too tight. The two rods should enter quite easily in the holes, and the X carriage should then move freely. If it is not the case, post-process these holes to enlarge them a little. And do not over-tighten the locking screws: check that the X carriage still moves freely.
Print spec
- Formats
- step
- Model files
- 2
- Total size
- 478.5 KB
- Largest file
- 297.2 KB
0 comments
You may also like 12 models
See all-

-

-
New -
New -
New -

-

-

-

-

-

-



