Adapter Tripod Tento 20x60

This adapter allows Tento 20x60 binoculars to be mounted to a Manfrotto/Bogen RC2 quick release clamp. I suspect it might also fit the Kronos 20x60, but I don't have one to test.

eSun PLA+
0.15mm layers
6 perimeters
60% grid infill

The main part should be oriented upright for printing, no supports. The cap should be printed top down. I prefer PLA+ for it's stiffness, toughness, and strong layer adhesion. That last attribute is very important for this model.

You will need two 25mm M3 screws + nuts.

The screw holes in the main body are tapped so that the screws stay in place when the top piece is removed. You will need to chase the threads with an M3 tap before the screws will fit. If you don't have a tap, you can drill the holes out to clearance and glue the screws in place.