Giá đỡ xe điều khiển XRAY X12

This is a handy profile car stand for the XRAY X12 1/12 car.  It will fit the chassis of the 2022-2023 models lightly so the car can be picked up and the stand stays with it.

There are 6.5mm relief holes on the bottom for a foam or rubber foot, you need to source (like the middle of a foam RC body hole dot.)

** Update 1/21:

We discovered that the brim to hold the car was just tall enough to touch the battery when mounted, this wasn't accounted for when designing.  It's not an issue in most cases, but if you tape the battery in there is some difficulty with the interference.  The brim was reduced to fix this, and the profile was updated slightly to tighten it against the chassis.