Vỏ Camera Hồng Ngoại Raspberry Pi

This case is suitable for the Raspberry Pi Night Vision Camera.
The housing does not require any screws and no support is needed for printing.

To screw the housing to a holder, a hole for a M3 screw is provided. The bracket is 6mm wide.

To ensure that the camera fits properly into the housing, the infrared lamps should be screwed on top of the camera's circuit board, as shown in the picture.

The cover has cut-outs for heatsinks. 
Heatsinks of a size of 10mm x 10mm should fit in easily. However, I could not test that yet. As soon as I know more about this, I will post an update.