ĐẾ NGANG CHO STARSHIP S24/B7

Original model

This support is to be used with my starship S24 and the booster B7.

Dimensions and Information 

• It is about 6 cm high and 8 cm wide. 
• There are 24 pieces to print.
• I printed it in about 5 hours. 

Settings

•  Infill: 10% 
• Support : No
• Raft : No

Printing tips 

• If some parts are loose or don't fit you can change the scale by +/- 1% in the slicer to get a better fit. 
• For small parts I advise you to print at a very low speed and a high temperature (to reduce the pressure in the nozzle and not to have warping), personally, I printed them at 220° and 5mm/s
• The parts are positioned in the optimal direction for printing. 
• For the base, it is recommended to print with 4 perimeters to avoid visible infill.

Post Printing 

• You may need to sand the areas where the pieces meet. 
• I also advise you to put glue to have a better solidity. 

Parts list