Chỗ Gác Kính Hình Chó

Needed parts:

• M4 Tap
• 2x M4 Screws, 8..15mm acceptable

Instructions

1. Print as oriented, no supports necessary
2. Remove sacrificial hole pattern where the nose part will mount
3. Tap the hole in the Nose and the Body part with an M4 Tap, but make sure not to go to deep, as the chips will accumulate in the holes. The hole in the nose is 20mm deep, and the hole in the body is 25mm deep, so mark your taps.
4. Assemble

If the recipient of the gift does not have a good sense of humor, cover up the screw mounting the feet with a 8mm sized disk from your slicer.