Vỏ Bỏ AirTag Kèm Móc Khóa

i didnt like how a lot of other models just “pops” the airtag into place, so i made one that secures it 100% with threads, it cannot fall out. i also made it as minimal as possible without a large bump for the keyring hole. once the cap screws on, its not really meant to come off (even though you can get it back out if you try), so i made it possible to change the battery without taking it out of the case.

settings i use:

• layer height: 0.12
• wall line count: 4
• printing temp: 215
• flow: 95%
• slicing tolerance: exclusive