Skip to main content
F3D
Vỏ Hoàn Chỉnh Cho Máy Đo Tải ATorch DL24 1

4 images

DIY

Vỏ Hoàn Chỉnh Cho Máy Đo Tải ATorch DL24

By silviutoderit_251139

Downloads
225
Likes
17
Views
1,739

Files 8 2.7 MB

  • dl24-case-bottom_1765825492.stlSTL · 213 KB
  • dl24-case-foot_1765825493.stlSTL · 259 KB
  • dl24-case-bottom-with-feet_1765825494.stlSTL · 262.2 KB
  • dl24-case-middle_1765825496.stlSTL · 191.6 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Complete case for the Atorch DL24 battery tester. Unlike other cases I found, this covers the heatsink and fan. This may not work with some larger fans out there, so your mileage may vary. I'm personally using it with an 80mm Noctua fan and the stock heatsink. 

Hardware required:

  • 4x M3x4.5mm heat-set inserts for middle case
  • 4x M3x10mm countersunk screws for bottom case

For the bottom, it's recommended to print the bottom case (dl24-case-bottom) separately from the feet (4x dl24-case-foot), and then gluing on the feet. However, a full bottom case file is available (dl24-case-bottom-with-feet). As a bonus, print the feet with TPU for some vibration damping. 

For the middle, it's recommended to print the middle case (dl24-case-middle) separately from the top (dl24-case-top), and gluing them together. However, they are available combined (dl24-case-middle-top). 

Print 4 of the buttons (dl24-case-button) and insert them into the middle case upside down, then place the DL24 in to hold them in place. 

Material: PETG or ASA

Infill: 15%+

Supports required for:

  • dl24-case-middle
  • dl24-case-middle-top (if you decide to print the middle and top together)

Read more Show less

Print spec

Formats
stepstl
Model files
8
Total size
2.7 MB
Largest file
1.4 MB

0 comments