Skip to main content
F3D
Bộ giảm thanh Crosman 1322 ren 2 mảnh 1

6 images

DIY

Bộ giảm thanh Crosman 1322 ren 2 mảnh

By maverickagm_259875

Downloads
231
Likes
17
Views
2,304
Remixes
1

Files 3 510.4 KB

  • 1322_threaded_suppressor_1765834523.stlSTL · 290.7 KB
  • 1322_barrel_band_suppressor_1765834524.stlSTL · 219.6 KB
  • SOURCES_1765834525.txtTXT · 107 B

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Details

Model ID
#118417
Category
DIY
Published

Description

A remix of Crosman 1377 suppressor V2. The original was a 5mm hole for 4.5mm (.177) pellet. This has a 7mm hole for 5.6mm (.22) pellet. I also made this a two piece threaded design. This makes managing supports simpler. Also, if you break something while installing the barrel band, you only have to re-print the barrel band instead of the whole thing. (Previously... print / wait 17 hours / install /snap / D'oh!)

I made some improvements to the fit (and I might make some more in the future). I made the pivot pin hole a bit larger. I also cut out some plastic between the barrel and air tube. I found the original lifted my barrel a bit. I still had to drill out the barrel hole just a bit. There's also some tabs on the part that insert into the air tube. I think they're there to ensure a tight fit. I just sliced them off with a paring knife.

Tinkercad: https://www.tinkercad.com/things/jvVJxgbGmf5-threaded-1322-suppressor

Printer:

Adimlab Gantry

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

0.16

Infill:

65 on suppressor, 80 on barrel band

Filament:

MG Chemicals PETG

Notes:

I used supports on the barrel band (touching build plate only). You will likely have to drill out the barrel hole a bit. You might have to sand the concave plastic area between the barrel and air tube to ensure the barrel is level with the air tube. In the uploaded model, I removed a bit of plastic to avoid having to do this, but haven't tested it yet. I used 150 grit sandpaper and an old chop stick.

Category: Hobby

Read more Show less

Print spec

Formats
stltxt
Model files
3
Total size
510.4 KB
Largest file
290.7 KB

0 comments

See all