Bộ che bụi cho giá sách IKEA Kallax

I designed this IKEA Kallax Hider for hiding the view from the backside of my IKEA Kallax. It prevents seeing the backside from books, folders and helps to collect less dust in these compartments. :)

To build you will need to print:
4xplate - 2h 30m each
4xcorner clamp - 3min each
1xcenter clamp - 5min each

I measured 33.5cm x 33.5cm for my compartment of my IKEA Kallax. If you have slightly bigger or smaller ones, just scale it for your desired size. One plate is 16.75cm x 16.75cm.

The clamps should be very tight. You can connect the parts with the clamps by using softly a hammer

Print Settings:

layer-height: 0.3mm

to print it faster I used:
infill: 5%
fill-pattern: grid
solid-layer-top: 3
solid-layer-bottom:2

you can print the clamps without infill :)