CHỖ ĐỂ LY LỚN VỪA VỚI FORD MAVERICK

I designed this cupholder with most of the popular large water bottles in mind, so it can hold Hydroflasks, Stanley cups, Owalas, etc. There are also 2 different sized sleeves that drop in to accommodate smaller canned drinks. 

I highly recommend printing this out of ABS to withstand the heat in the car during the summer, you may be able to get away with PETG, but mine in ABS stood up to +100F summer days this past year.

This is a large print that will benefit from as many walls, top/bottom layers, and infill you are willing to throw at it. 

Cupholder Recommendations:

Walls: 4-5

Top/Bottom: 4-5

Infill: 70%

Supports: Yes

Orientation: I printed with the bottom on the baseplate, and it was a bit of a hassle to get the supports out of the structures between the cupholder and the cleat. Printing upside down may be easier to remove supports, the trade-off being using more material.

Drop-in Sleeve Recommendations:

These are meant to be flexible to have a bit of squeeze and flex on the cup/can. So should be printed out of TPU, flexible PLA, or the likes. There is a small flat spot on the perimeter of the sleeves that is meant to register toward the inside where the two cupholders meet.

Walls: 2-3

Top/Bottom: 3-4

Infill: 15-25%