
MK4 Hotend Fan Shield v3 có Lưới Tổ Ong
Remix of MK4 Hotend Fan Shield - Chặn nhiễu loạn / luồng gió từ quạt hotend - Fan shroud - REMIX By daytrader_16894
- Downloads
- 69
- Likes
- 9
- Views
- 577
- Remixes
- 0
- Comments
- 0
Files 2 1.7 MB
- Thick_Hex_Fan_Shield_0.4n_0.1mm_PLA_MK4IS_1h19m_1765820626.bgcodeBGCODE · 1.3 MB
- Thick_Hex_Fan_Shield_1765820625.stlSTL · 386.4 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #117422
- Category
- Máy In 3D
- Published
Description
I printed in 0.1 layers. I'm sure 0.20 layers could be used but did not try.
Supporting this kind of sucks but it's doable. See attached image. Honeycomb facing down.
I smart-filled the honeycomb and surrounding under-area with supports, but found it was hard to take all the supports off after printing. So I used the paint supports option to exclude the corners. Helps get a finger or tool in there to pull supports off without risking snapping any of the thin-surrounding edges.
About 6.9grams per PrusaSlicer - 3 grams more than the original v3 Fan Shield
About double the print time due to using 0.10 layers, all the added support, +the hexagon guard.
0.20 layers and same supports cuts time to about 50 minutes.
Print spec
- Formats
- bgcodestl
- Model files
- 2
- Total size
- 1.7 MB
- Largest file
- 1.3 MB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -
New -
New -

-

-

-

-


