Ốp Sườn và Pát Thân Xe Sau Arrma Vendetta

These are 3 piece side skirts that include a minor mudguard up front and a rail on the bottom to help (in theory) keep air from escaping the sides of the car and help channel the air to the rear diffuser. I printed these 7 walls thick (2.8) and with 50% infill with support every where turned on. I printed in clear Sainsmart Petg at 240 nozzle and 70 bed temp using a magnetic/textured build surface. When installing it's a tight fit to slip the two mounts over the plastic mount on the car. I have a hot air station and just heated them up slightly and fitted them a few times gradually and they end up a very firm fit after they slide on. The screw holes are very slightly off but nothing that some persistence or a drill bit won't solve. If anyone wants to make that small correction feel free to remix the design and upload. I've also included a modified rear body post that supports the rear deck of the body shell and helps eliminate flex in the shell that gets created by the wing downforce.

Category: R/C Vehicles