
Cánh quạt bơm cho bơm JEWEL Aquarium Eccoflow 500
- Downloads
- 71
- Likes
- 16
- Views
- 564
- Remixes
- 0
- Comments
- 0
Files 2 847.1 KB
- Pump_Impeller_1765810092.stlSTL · 438.5 KB
- Pump_Impeller_1765810093.3mf3MF · 408.6 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #117115
- Category
- Đồ Gia Dụng
- Published
Description
This is a pump impeller (w/o magnet & shaft) for JEWEL Aquarium Eccoflow pump 500.
It is rather small part and should be printed with 0.2 nozzle. Standard 0.4 nozzle did not give satisfying quality. Supports are required. Place the model on a table as is. Layer 0.12, walls 0.2 mm.
Check out Cura project file for printing parameters. Please carefully pay attention to cooling parameters especially ‘fan setting override’ in supports section. I would recommend to not override common fan settings. Otherwise set fan speed for supports to twice faster than for the model. I use custom fan duct with two 5015 coolers so fan values in the project file are rather low. Change fan settings according to your part cooling system.
Print spec
- Formats
- 3mfstl
- Model files
- 2
- Total size
- 847.1 KB
- Largest file
- 438.5 KB
0 comments
You may also like 12 models
See all-

-

-

-

-

-
New -

-

-

-

-

-


