
Pát Gắn Cảm Biến Danfoss Ally Lên Kệ Billy Ikea
- Downloads
- 13
- Likes
- 0
- Views
- 331
- Remixes
- 0
- Comments
- 0
Files 1 77.9 KB
- AllyBillyMount_outside_1765818421.stlSTL · 77.9 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #116972
- Category
- Đồ Gia Dụng
- Published
Description
This bracket is meant to mount a Danfoss Ally room sensor to an Ikea Billy shelf.
I found the necessity to glue it to some surface using the 3M sticky tape a bit annoying since it could potentially destroy the surface. Just putting it on a shelf somewhere, lying on its back also did work out because the sensing was impaired by this orientation.
As a consequence this design was created. The bracket can be mounted on a Billy or PAX shelf using two of the 5mm holes found on these. When mounted, the sensor will be located inside the billy shelf but close enough to the outside to properly sense the temperature and humidity of the room.
The uploaded design is meant to be mounted on the left hand side of the shelf (looking at it). If you would like to attach it to the other side I recommend using the mirror feature in your slicer.
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 77.9 KB
- Largest file
- 77.9 KB
0 comments
You may also like 12 models
See all-

-
New -

-

-

-

-

-

-

-
New -

-

