Cà vạt ca rô

This is model of elegant plaid tie made using my 3D printable fabric.

There are 2 sizes in the files below. The shorter one fits on Prusa MINI bed.

You can also have the FULL sized model witch you can find here: https://www.printables.com/model/713469-plaid-tie-full-size.

There is a hole in the upper part to tie it around the neck. I used stretchy string about 60cm long. After tying you can hide the string under the collar.

Printing:

There are no special printing requirements, NO supports.

Printig tips:

1. Use concentric infill for the top layer.
2. Use textured plate. The tie will look nice from the other side as well.
3. To make even smaller size use only XY scale in the slicer.
4. To make larger size I would use XYZ scaling in the slicer.

Also check out:

https://www.youtube.com/channel/UChKp-968z1i5PN29gbR7YfA

https://www.cgtrader.com/rorys3d