
Núm chỉnh mặt bàn CZ 300 Crazy3dPrint có khóa
Remix of Ender 3 S1 Plus - Nút Vặn Khóa Chỉnh Mặt Bàn By AJCam44_572626
- Downloads
- 39
- Likes
- 5
- Views
- 301
- Remixes
- 0
- Comments
- 0
Files 2 8.1 MB
- CZ300KnobAndSnapSmall_1765803196.3mf3MF · 1.7 MB
- CZ300KnobAndSnapSmall_1765803197.stlSTL · 6.4 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #114455
- Category
- Máy In 3D
- Published
Description
In order to print properly, you must enable support all and I had to enable brim, you may have better luck than I did without.
Depending on your printer you may have to ream out the holes, they are slightly larger than the bolt diameter.
when placing the nuts, they are a tight fit, so you may have to heat them up first and press them in.
You may have a slight clearance issue with the rear right knob, due to the z rail bracket. you can either lower the bracket slightly, file down the bracket, or shorten the knob.
4x m3 nuts are required
Print spec
- Formats
- 3mfstl
- Model files
- 2
- Total size
- 8.1 MB
- Largest file
- 6.4 MB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -
New -

-
New -
New -

-

-


