Skip to main content
F3D
Hộp Chống Ẩm Cho Xô 5 Gallon 1

5 images

Máy In 3D

Hộp Chống Ẩm Cho Xô 5 Gallon

By GerryPB

Downloads
28
Likes
13
Views
1,307

Files 6 28.4 MB

  • Funnel_0.4n_0.2mm_PLA_MK4IS_1h38m_1765802808.gcodeGCODE · 11.8 MB
  • Final_Tray_Version_0.4n_0.2mm_PLA_MK4IS_1h57m_1765802810.gcodeGCODE · 12.2 MB
  • Spacer_Pin_0.4n_0.2mm_PLA_MK4IS_52m_1765802812.gcodeGCODE · 4.2 MB
  • Funnel_1765802806.3mf3MF · 190.9 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

This is a dry box for five rolls of filament that uses a common 5 gallon bucket and screw lid. The trays fit around the bottom perimeter of the bucket and there is room to stack five filament rolls inside. I also add a bluetooth humidity sensor inside. The ones I use are Thermopro TP359 and TP357. I find that the relative humidity will stay at about 10 to 15%. The funnel is custom fit to the curve of the trays. The trays will hold 2lbs of Silica Gel. It will recharge in the oven at 250F for 3 hours on a cookie sheet. There are spacer pins if you want to use them to connect the trays.

The bucket is a standard hardware store type. The screw lids are available on amazon. I have used Gamma brand and 72HRS brand. Both are fine. It takes a lot of force to install the initial ring but that is a one time install.

Note: I find that spools made of cardboard tend to take longer for the relative humidity to drop.

Here is a link to my hygrometer mount…

https://www.printables.com/model/720989-hygrometer-holder

Read more Show less

Print spec

Formats
3mfgcode
Model files
6
Total size
28.4 MB
Largest file
12.2 MB

0 comments

See all