Skip to main content
F3D
Tháp nhiệt Prusa XL cho PLA, PETG, ABS 1

2 images

Máy In 3D

Tháp nhiệt Prusa XL cho PLA, PETG, ABS

Remix of Tháp nhiệt độ tất cả trong một - GCode cho PLA & PETG By Tronnic

By Reef’eneer

Remixes
1

Files 7 23.4 MB

  • XL_Temp_Tower_ABS_230-270_0.6n_0.15mm_ABS_XL_4h2m_1766604901.gcodeGCODE · 5.3 MB
  • XL_Temp_Tower_PETG_220-260_0.6n_0.15mm_PETG_XL_3h16m_1766604902.gcodeGCODE · 6 MB
  • XL_Temp_Tower_-_PETG_-_210-250_0.6n_0.15mm_PETG_XL_3h27m_1766604904.gcodeGCODE · 6 MB
  • XL_Temp_Tower_PLA_190-230_0.6n_0.15mm_PLA_XL_3h1m_1766604905.gcodeGCODE · 5.5 MB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Description

Building on the awesome job of @Tronic with the Temp Tower, I have remixed one suitable for the Prusa XL.

The supplied G-Codes are sliced using PrusaSlicer 2.6 Release Candidate 1 at 0.15 layer height using all stock Prusa Profiles for the 0.6mm nozzle, with minor changes.

Perimeter Generator is set to classic instead of Arachne as the small cones weren't being produced correctly.

Infill Pattern is set to Grid instead of Gyroid (personal preference)

Elephant Food Compensation is turned off.

THE G-CODES ARE SLICED FOR THE PRUSA XL ONLY!!!

G-Code Information

  1. PLA G-Code:
    • Base prints with 215°C
    • Bed 60°C
    • Lowest Section prints at 190°C
    • Highest Section prints at 230°C
    • Each section increases by 5°C
    • 0.15 DETAIL Layer Height Prusa Profile
    • 0.6 Nozzle Diameter
  2. PETG G-Code:
    • Base prints with 240°C
    • Bed for first layer is 85°C
    • Bed at 90°C for the rest of the print
    • Lowest Section prints at 220°C
    • Highest Section prints at 260°C
    • Each section increases by 5°C
    • 0.15 DETAIL Layer Height Prusa Profile
    • 0.6 Nozzle Diameter
  3. ABS G-Code:
    • Base prints with 255°C
    • Bed for first layer is 100°C
    • Bed at 105°C for the rest of the print
    • Lowest Section prints at 230°C
    • Highest Section prints at 270°C
    • Each section increases by 5°C
    • 0.15 DETAIL Layer Height Prusa Profile
    • 0.6 Nozzle Diameter

It's recommended that you watch the lowest section as that is the lowest temperature and if you were to get a clog, then you can stop the print immediately.

All the .3mf files have been supplied also.

Read more Show less

Print spec

Formats
3mfgcode
Model files
7
Total size
23.4 MB
Largest file
6 MB

0 comments

See all