Mắt Xích Rời

Please note, that this model can print without supports.  Also, one end is split so that you can join the links together (the split end slides over the solid pinched area of the next link). 

Depending on the material used, the small gap on the “open” end can partially fuse.  If this happens, you will need to use a knife to pop those ends apart from each other so that the links can be joined together.

As always, I am very open to feedback so that I may review and improve my models.

The model depicted was printed in Galaxy Black PETG with a 0.6mm nozzle and 0.4mm draft layer height.  Each link will print in approximately 25 minutes.