Miếng Kê Tay Bàn Phím Keychron V1

This is a simple 18m high wrist rest I designed to fit my Keychron V1, however, it should work well with any 75% or ten-keyless layout keyboard. 

I designed this wrist rest to have a more squared-profile, so your wrists sit higher relative to the keyboard. I found a lot of the existing models for wrist rests feature a significant taper, which causes me to pinch my wrists in an awkward position.

Print standing up to make the curved section smooth. The files have been slightly offset so the 2 pieces will only contact the bed in the right print orientation.

The file is pre-split, to let it be easily printed on most common printers (Ender 3, Pruha i3, etc), so the 2 sections need to be glued together if you want a solid wrest. I used gorilla glue, but anything should work.

If you want the bottom of the rest to be more grippy on the desk, try applying some electrical tape, or duct tape to the bottom to give it a more rubberized surface.