Kệ Để Đồ Nhà Tắm / Shower Holder

This print is done with standard PLA

Polyterra 1,75, cotton white to be exact.

Printed on a BambuLab.

Duration: 1h 55min 

Suports: Yes, i used tree supports as seen on the photo.

Layerhight: 0,2 mm

Wallthickness: 2

Infill: 15%,  i would concider a 20/25% infill if i wouldn't be running out of filament.

for installing the holder i took andvantage of the rosettes on the shower.

you can screw back the rosettes a little bit, put the holder behind and screw the rosettes back in thight. this way the holder is leaning on the outside of the rosette and is held in place by the rosette too!