Kẹp Dây Tóc Cyclopes Cho Máy Prusa

Simple way to use the teflon tube included with the Cyclopes dryer to route filament while being dehumidified. This model uses the rubber insert from the holes in the clear upper case in the dryer. Pull one from the upper case and pop it into this print to keep the teflon tube from sliding around. It clips to the top frame of the Prusa, exactly like the spool holder that comes with the printer. 

Settings aren't critical, but below is what I used - 

• 0.4mm nozzle
• 0.2mm layer height
• PLA