
Retrofit Laser Trotec với ống CO2 40W
- Downloads
- 10
- Likes
- 2
- Views
- 433
- Remixes
- 0
- Comments
- 0
Files 5 445.1 KB
- tube_holder_cornerRight_1765781503.STLSTL · 98.1 KB
- mirroir_centre_1765781504.STLSTL · 10.2 KB
- amp_rem_tre2_1765781505.STLSTL · 102.1 KB
- tube_holder_cornerLeft_1765781505.STLSTL · 110.8 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #108861
- Category
- DIY
- Published
Description
I have an old Trotec laser engraver. It was built in 1998 and worked quite well until this summer 2023. So I would say that it was a very reliable machine but it now suffers from its old age:
- laser tube is dead
- software is very very old fashioned and runs (tries to run) under windows 95 operating system
So it was time to trash this machine... But it looked so professionnal that I decided to refurbish it with more modern electronics.
- As I am an hobbyist I couldn't afford to buy a new RF laser tube, so I decided to change it to a cheap 40W CO2 tube
- As I love ESP32 and micro controllers I decided as well to design my own controller boards based on GRBL FluidNC software.
Follow this project to see how all this can work as expected !
Result here : https://youtu.be/0KS32yQQGEo
Full project is open sourceOpen hardware and accessible on my Hackaday's project page : https://hackaday.io/project/193893-retrofitting-an-old-laser-engraver
Category: Electronics
Print spec
- Formats
- stl
- Model files
- 5
- Total size
- 445.1 KB
- Largest file
- 123.8 KB
0 comments
You may also like 12 models
See all-

-

-

-
New -

-
New -

-

-

-

-
New -


