Kẹp Bàn In Cho ADXL345

I was looking around the web for a nice small accelerometer for the ADXL345.

I noticed a lot of them are multiple use for extruder and bed but I have one permanently on my extruder but the bed one I needed to find a nice alternative.

All you need is an M3 Nut and Screw (I used an old PC Case thumb screw).

I slid the screws in with an set of tweezers then screwed the thumb screw in.

Printed with:

• Infill: 80%
• Material: PLA +
• Layer Height: 0.16

When I perfect it I will upload the Model file.