Ống nối bàn thay tã Graco Pack 'n play

Somewhere between kids we lost the attachment tubes that connect the changing table to the Pack ‘n play, so I designed me some! If you’re in the same pickle, hope this helps! And if you need the kickstand part, there's a couple of models on Printables but I particularly like this one by Jbolling.

The original part has a spring loaded button that clicks in place. I opted for a simpler approach with a printed peg. I had to print it oversized for a nice pressure fit; 110% did the trick for me. Make sure it's snug! You don't want it falling out and your baby putting it in their mouth. Which reminds me, use this design at your own risk! I am not responsible for any accidents or damages.

No supports are needed but I did use a brim. I printed it a little hotter than usual, and 4 perimeters with a .4 nozzle. It is plenty strong and I don't have concerns using it. But, again: I am not responsible for any accidents or damages. You take care of your kids, I take care of mine :)