Móc Trang Trí Die-Hard

I've seen this concept as a cardboard and tinfoil craft before, just thought it might be nice as a 3D-Printed version.

I made it from scratch in TinkerCAD. https://www.tinkercad.com/things/i5AELgmv15r-die-hard-ornament/

I have included the images to print in both the original size and one resized to 65mm x 38mm to fit.

There is a template to use to cut out the photo, but if you don't have a really sharp knife, just use it to draw a line on the picture and then cut it out with scissors.

There is a "thinner" version that snaps off at the base every time I try to remove it from the plate, so I have made a "repair-base" that you can print to still use a broken one if you want. The "thicker" version prints fine and comes off in one piece if you're gentle.

I print everything with a 0.6 nozzle so the walls are sized to print with that.

If you use a different size you might end up with artifacts on the surface from the slicer placing infill.

I made the hook to print separately and will have to be glued on, trying to print it with it attached to the vent results in a bunch of supports or a reduced quality on the vent so it's separate. One hook is meant to be glued more towards the back, the one with the removable brim is for mounting it dead center at the top. There is a 3rd & 4th hook that has the ring more forward or backwards to better balance on the tree.

Print Settings

Printer Brand:

VoronDesign

Printer:

Voron Trident 350

Supports:

No

Resolution:

0.4 layer height with a 0.6 nozzle

Infill:

30

Filament:

Bblife PLA

Silk Metallic Silver

Category: Scans & Replicas