Skip to main content
F3D
Giá đỡ nạng - Crutch holder 1

3 images

Sức Khỏe

Giá đỡ nạng - Crutch holder

By Tri_Engineer_951095

Downloads
130
Likes
12
Views
1,118

Files 1 149.8 KB

  • crutchholder_1765765440.3mf3MF · 149.8 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#105767
Category
Sức Khỏe
Published

Description

Der Halter verhindert, dass die Krücken ungewollt umfallen, wenn sie an eine Wand gelehnt werden. Der Halter ist für Krücken mit einem Durchmesser von 22mm gedacht. Für einen besseren Halt muss ein 1mm dickes Stück Moosgummi in die Halter geklebt werden. Etwas ähnliches wie Textilband könnte ebenfalls funktionieren. Befestigt wird er an einer Krücke mit zwei Kabelbindern oder Klettverschlussbändern.

Ich habe den Halter aus PEGT gedruckt, und er hat mittlerweile schon einige Besuche im Dampfbad überstanden. Der Halter kann komplett ohne Support gedruckt werden.

The holder prevents the crutches from falling over unintentionally when they are leaned against a wall. The holder is designed for crutches with a diameter of 22mm. For a better hold, a 1mm thick piece of foam rubber must be glued into the holder. Something similar like textile tape could also work. It is attached to a crutch with two cable ties or Velcro straps.

I printed the holder with PEGT. The holder can be printed without supports.

Read more Show less

Print spec

Formats
3mf
Model files
1
Total size
149.8 KB
Largest file
149.8 KB

0 comments

See all