Miếng Đệm Thớt IKEA RASKOG HOGSMA

The HÖGSMA cutting board from IKEA sits too loosely on the RÅSKOG utility cart, these spacers reduce the wiggle and prevent the board from falling into the top tray. 

Uses four 0.5" (12mm) wood screws but sticky tape/liquid adhesive can be used.

Printed in OVERTURE PETG 1.75mm plastic, since it can better stand up against hot water than PLA should I use it as a cutting board.

Updated 2024-01-05

There seems to be some difference in tolerance based on recent feedback, I've included a slimmer edgeclip, if you're not sure what you need and can't measure the difference then print just one clip first instead of printing all four of one size.

IKEA Components here:
https://www.ikea.com/us/en/p/raskog-utility-cart-black-90333976/
https://www.ikea.com/us/en/p/hoegsma-cutting-board-bamboo-90446619/