Đế Dựng Đầu Đọc Thẻ Nhớ Micro SD và USB

Hello Everyone

I created a Stand for my Micro SD card readers. I am sharing this project, maybe it will be useful to someone. It can also be used for pendrives. At the bottom of the Stand is located there is space for 4 non-slip silicone pad with a maximum diameter of 8mm. The height of the silicon pad I used is 1.5 - 2.5mm. You can buy them in any large DIY store or furniture accessories store for about 1.50 euros for 50 pieces. Their use is not mandatory. If you have a textured PEI board, you can place the model with the top side down as in the photo.

When you complete the project, please share a photo and a comment. Thank you and have a nice day.

Dimensions :

• 80 x 30 x 20mm length x width x height

How to print ? :

• Material : Any
• Layer Height : 0.2mm
• Infill : 10%
• Wall Loops : 2
• Bottom Layers : 4
• Top Layers : 4
• Support : No
• Brim : No