Chân Đế Thay Thế Cho Case Thermaltake V1

This is a 2 part replacement foot for the Thermaltake V1 ITX case.

The inner part (nut) carries an M3 nut. The fit here is snug, so you may need to press it in. The hole through the foot is sized so an M3x8 bolt will not protrude past the nut on the inside of the case.

You will need (per foot):
1x M3 Nut
1x M3x8 socket head cap screw

The foot diameter and height closely match the original, so you can replace just one foot as needed.

I printed the nut part in ABS and the foot itself in PLA, supports enabled for both. If replacing all 4 feet, printing them in TPU might be a good idea.