Skip to main content
F3D
Ống dẫn quạt MK4 - Phiên bản chỉnh sửa 1

2 images

Máy In 3D

Ống dẫn quạt MK4 - Phiên bản chỉnh sửa

Remix of Ống Dẫn Quạt Cho MK4/MK4S Extruder By Darrin_322373

By daytrader_16894

Downloads
575
Likes
93
Views
2,493

Files 2 720.9 KB

  • Nextruder_Fan_Deflector_tweaked_v2_1765755279.stlSTL · 491.6 KB
  • Nextruder_Fan_Deflector_tweaked_1765755280.stlSTL · 229.3 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#101977
Category
Máy In 3D
Published

Description

Tweaked Version :-)

  • smaller
  • only 1.1g instead of 1.6g
  • less air restriction
  • fast print → 8min.

V2 more tweaked :-)

  • geometry tuned for more airflow
  • only 0.9g

Original Text Model & Text from Daarin:

Fan duct for the Nextruder hotend fan.  

I was having issues printing PA6-CF and uneven cooling causing warp on one side of the models being printed.  No matter the print orientation, the right side of the model would show signs of uneven cooling and slight warping.  After a little investigation I realized the hot end fan was directing air out the right side of the Nextruder, blowing down on the build plate.

This duct redirects the airflow up instead of out.  The duct snaps into place using the existing hex spacer nut and a slot in the X carriage.  Clearances on the right side of the nextruder are pretty tight so please make sure to fully seat the duct when installing, you should be able to use a piece of paper between the Z screw shaft and the duct to confirm clearance.  Print orientation is important, it needs to be printed on it's side so the clip has enough strength.   Printed in PTEG.

Finally i would like to thank Daarin for providing his cad file :-)

Read more Show less

Print spec

Formats
stl
Model files
2
Total size
720.9 KB
Largest file
491.6 KB

0 comments

See all