Apprentice Cowl S 2 Mini 1.2M

Reworked one I found elsewhere because the measurements were not to my liking.

I didn't compensate for the down thrust on the motor but other than that it fits like a glove while still using the spinner. The original didn't either. ( did this for a buddy in need of the cowl )

Printed nose up with generic PLA.

0% infill

Top Layers = 4 ( you could probably get away with 2 or 3 )

I actually stopped the print when it got to the shaft cut out area.

Bottom Layers =0

I used a brim to ensure it sticks to the bed.