Router Table Infeed Guide (Jess-Em)

I designed this infeed guide to work with a router table I built using Jess-Em components. It requires three 1 inch ¼-20 bolts, a 608 skate bearing, and a couple of o-rings that fit snugly on the outer ring of the bearing. The nuts go in the knobs and a couple of drops of super-glue is handy here. I had to try a few different o-rings before I found some that were the right size and had a little sponginess to allow them to work well. Included is a small shim that goes inside the 608 bearing to adapt it to the bolt diameter. I also included a left hand guide plate.