Tiêu đề Giá treo trần hoặc treo tường cho máy bay RC Tóm tắt

Low wing can mount inverted while high-wing can mount rightside up.

The rods are mounted at an approximately 15deg angle meaning the plane will be pressed against the surface as it is inserted, providing a secure hold with friction alone.

Print as a single piece with no supports.

A single 10x1000mm (3/8x36in) rod (aluminum, wood, carbon, etc) can be cut in half and inserted into the holes. Trim length as desired.

A 10x65 (3/8x2.5in)mm lag screw is used to secure it to a stud. Smaller screws with washers can also be used.