Ender S1 flat cable and raspberry pi camera holder

A flat cable holder for the ender s1 plus, that will also hold a raspberry pi camera (Lens diameter 14mm). I've added a small piece of electrical tape on the top of the lens to make it fit tightly in the lens holder. I've used an OV5647 5MP camera module with a 3.6mm focal length lens. (I used these: https://a.aliexpress.com/_Eygm7SJ , but any with same 14mm lens diameter should work). The camera placement is compatible with a 0 y-offset bed sensor, as it is positioned closer to the gantry. The bracket itself snaps on the gantry by slightly bending the arm that clips to the front. Support is only needed for the overhang on the bracket, not on the lens holder. See also the https://www.f3d.vn/3d-model/54244-gia-do-cap-truc-z-cho-may-in-3d-ender-s1 clip I made for the flat cable that attaches to the leadscrew for a complete solution. If you decide to make this model, let me know what you thought of it! I would appreciate some feedback and a make!